How to Replace Blend Door Actuator on Dodge Sprinter?

The Procedure to replace Blend Door Actuator.

The dodge Blend door Actuator replacing details and diagrams are as follows:---

1. Disconnect and isolate the battery negative cable.
2. Disconnect the wire harness connector from the recirculation door actuator.
3. Disconnect the vacuum line from the recirculation door actuator.
4. Remove the two screws that secure the recirculation door actuator to the ventilation housing.
5. Disconnect the actuator shaft from the recirculation door pivot lever and remove the actuator from the vehicle.

To install:

1. Connect the actuator shaft to the recirculation door pivot lever.
2. Install the two screws that secure the recirculation door actuator to the ventilation housing. Tighten the screws to 17 inch lbs. (2 N·m).
3. Connect the vacuum line to the recirculation door actuator.
4. Connect the wire harness connector to the recirculation door actuator.
5. Reconnect the battery negative cable. 
   
   
   
   Fig. Exploded view of recirculation (blend) air door actuator.

------------------------

1. Disconnect and isolate the negative battery cable.
2. Remove the steering column opening cover from the instrument panel.
3. Remove the driver side front floor distribution duct from the instrument panel.
4. Remove the three screws that secure the blend door actuator to the driver side of the HVAC housing.
5. Remove the blend door actuator from the HVAC housing and disconnect the HVAC wire harness connector and remove the actuator from the vehicle.

To install:

1. Position the blend door actuator to the driver side of the HVAC housing and connect the wire harness connector to the actuator.
2. Install the blend door actuator onto the HVAC housing. If necessary, rotate the actuator slightly to align the spline on the actuator with the blend-air door linkage.
3. Install the three screws that secure the blend door actuator to the HVAC housing. Tighten the screws to 17 inch lbs. (2 N·m).
4. Install the driver side front floor distribution duct.
5. Install the steering column opening cover.
6. Reconnect the negative battery cable.
7. Initiate the Actuator Calibration function using a scan tool

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html