Exhaust Manifold Removal on Chrysler Pt Cruiser?

The details to replace Chrysler Exhaust Manifold.

The complete step by step details with diagrams.

The procedure to remove/install Exhaust manifold is as follows:----


FOR Turbocharged Engines
The exhaust manifold on turbocharged model is removed as an assembly with the turbocharger.


AND
FOR Non-Turbocharged Vehicles the details are as follows:-----

1. Remove or disconnect the following:
   
   
   The negative battery cable

   The air cleaner assembly and bracket

   The throttle and speed control cables

   The Manifold Absolute Pressure (MAP) sensor electrical connector

   The power steering reservoir, move it aside. DO NOT disconnect the fluid lines.

   The coolant recovery bottle

   The exhaust manifold upper heat shield

   The exhaust pipe from the manifold

   The engine wiring heat shield

   The manifold support bracket

   The lower exhaust manifold heat shield

   The upstream Heated Oxygen Sensor (HO ₂ S) connector

   The exhaust manifold and discard the gasket
2. Thoroughly clean the mating surfaces.

To install:

Fig. Torque the exhaust manifold bolts in sequence

1. Install or connect the following:
   
   
   The new gasket

   The exhaust manifold and torque the bolts, in sequence, to 17 ft. lbs. (23 Nm)

   The alternator bracket bolt, if loosened

   The exhaust manifold heat shields and torque the bolts to 105 inch lbs. (12 Nm)

   The exhaust manifold support bracket

   The engine wiring heat shield

   The upstream HO ₂ sensor wiring connector

   The exhaust pipe to the manifold and torque the bolts to 21 ft. lbs. (28 Nm)

   The coolant recovery bottle

   The power steering pump reservoir

   The MAP sensor connector

   The throttle and speed control cables

   The air cleaner bracket and assembly

   The negative battery cable
2. Start the vehicle and check for leaks, repair if necessary.

These details will help.

Thanks.           

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html